×

PCA9539PW

Low-voltage 16-bit I²C and SMBus low-power I/O expander with interrupt output, reset pin and configuration registers

The PCA9539 provides 16 bits of General Purpose Input/Output (GPIO) expansion with interrupt and reset for I²C-bus/SMBus applications. It is designed for a wide voltage range of 2.3 V to 5.5 V. Nexperia GPIO expanders provide an elegant solution when additional IOs are needed while keeping the interconnections to a minimum, for example, in ACPI power switches, sensors, push buttons, LEDs and fan control. The PCA9539 contains a set of 8 bit Input, Output, Configuration and Polarity Inversion registers. At power up all IOs default to inputs. Each IO can be configured as either input or output by changing the corresponding bit in the configuration register. The data for each input or output is stored in the corresponding input or output register. The polarity inversion register can be programmed to invert the polarity of the read register. The PCA9539 has an open-drain interrupt output which is activated when any one of the GPIO changes from its corresponding input port register state. INT can be connected to the interrupt input of a microcontroller. By sending an interrupt signal on this line, the remote I/O can inform the microcontroller if there is incoming data on its ports without having to communicate via the I²C-bus. Thus, PCA9539 can remain a simple slave. The power on reset sets the registers to default values and initializes the device state machine. The RESET pin can be used to achieve same reset functionality without power down/up cycling by keeping active low. The state machine and the registers are in their default state until the RESET input is once again HIGH. This input requires pull up to VCC. The PCA9539 has two address pins A0 and A1 which can be used to configure the I²C bus slave address of the device. It allows up-to four devices to share the same I²C-bus/SMBus.

Features and benefits

  • I²C-bus to parallel port expander

  • Operating power supply voltage range of 2.3 V to 5.5 V

  • Ultra low standby current consumption:

    • 1 µA (maximum)

  • Schmitt-trigger action allows slow input transition and better switching noise immunity at the SCL and SDA inputs

    • Vhys = 0.10 × VCC (typical)

    • Noise filter on SCL and SDA inputs

  • 5 V tolerant I/Os

  • 16 I/O pins which power up configured in input state

  • Open-drain active LOW interrupt output (INT)

  • Reset input (RESET) for resetting PCA9539 to default values

  • 400 kHz Fast-mode I²C-bus

  • Internal power-on reset

  • No glitch on power-up

  • Latched outputs with 25 mA drive maximum capability for directly driving LEDs

  • Latch-up performance exceeds 100 mA per JESD78, Class II

  • ESD protection:

    • HBM ANSI/ESDA/JEDEC JS-001 Class 2 exceeds 2000 V

    • CDM ANSI/ESDA/JEDEC JS-002 Class C3 exceeds 1000 V

  • TSSOP24 package: plastic thin shrink small outline package; 24 leads; body width 4.4 mm

  • Specified from -40 °C to +85 °C

参数类型

型号 Product status VCC (V) Logic switching levels Power dissipation considerations Tamb (°C) Package name
PCA9539PW Production 2.3 - 5.5 CMOS low -40~85 TSSOP24

封装

型号 可订购的器件编号,(订购码(12NC)) 状态 标示 封装 外形图 回流焊/波峰焊 包装
PCA9539PW PCA9539PWJ
(935691435118)
Active PCA9539PW SOT355-1
TSSOP24
(SOT355-1)
SOT355-1 SSOP-TSSOP-VSO-WAVE
SOT355-1_118

环境信息

型号 可订购的器件编号 化学成分 RoHS RHF指示符
PCA9539PW PCA9539PWJ PCA9539PW rohs rhf rhf
品质及可靠性免责声明

文档 (9)

文件名称 标题 类型 日期
PCA9539 Low-voltage 16-bit I²C and SMBus low-power I/O expander with interrupt output, reset pin and configuration registers Data sheet 2023-04-25
SOT355-1 3D model for products with SOT355-1 package Design support 2020-01-22
pca9539 PCA9539 IBIS model IBIS model 2014-08-13
Nexperia_document_leaflet_I2C_GPIO_expanders I2C GPIO Expanders 2023 Leaflet 2023-04-26
Nexperia_package_poster Nexperia package poster Leaflet 2020-05-15
SOT355-1 plastic, thin shrink small outline package; 24 leads; 0.65 mm pitch; 7.8 mm x 4.4 mm x 1.1 mm body Package information 2022-06-22
SOT355-1_118 TSSOP24; Reel pack for SMD 13''; Q1/T1 product orientation Packing information 2020-04-21
PCA9539PW_Nexperia_Product_Reliability PCA9539PW Nexperia Product Reliability Quality document 2023-05-29
SSOP-TSSOP-VSO-WAVE Footprint for wave soldering Wave soldering 2009-10-08

支持

如果您需要设计/技术支持,请告知我们并填写 应答表 我们会尽快回复您。

模型

文件名称 标题 类型 日期
pca9539 PCA9539 IBIS model IBIS model 2014-08-13
SOT355-1 3D model for products with SOT355-1 package Design support 2020-01-22

订购、定价与供货

型号 Orderable part number Ordering code (12NC) 状态 包装 Packing Quantity 在线购买
PCA9539PW PCA9539PWJ 935691435118 Active SOT355-1_118 2,500 订单产品

样品

作为 Nexperia 的客户,您可以通过我们的销售机构订购样品。

如果您没有 Nexperia 的直接账户,我们的全球和地区分销商网络可为您提供 Nexperia 样品支持。查看官方经销商列表

How does it work?

The interactive datasheets are based on the Nexperia MOSFET precision electrothermal models. With our interactive datasheets you can simply specify your own conditions interactively. Start by changing the values of the conditions. You can do this by using the sliders in the condition fields. By dragging the sliders you will see how the MOSFET will perform at the new conditions set.

可订购部件

型号 可订购的器件编号 订购代码(12NC) 封装 从经销商处购买
PCA9539PW PCA9539PWJ 935691435118 SOT355-1 订单产品